HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
BP219

Toy Hauler set up (wheel chocks, tiedown rings) ?

6 posts in this topic

I just purchased a toy hauler motor home. I've got the Rider Cargo wheel chocks and quick release mounts. How have folks mounted them to the floor when it is hard to get to the bolts from underneath due to the gas tank and other items being in the way ? Thanks !

BP

Edited by BP219

Share this post


Link to post
Share on other sites

I just purchased a toy hauler motor home. I've got the Rider Cargo wheel chocks and quick release mounts. How have folks mounted them to the floor when it is hard to get to the bolts from underneath due to the gas tank and other items being in the way ? Thanks !

BP

I have a fuzion toy hauler and installed the risk racing setup.

Had to remove the one gas tank and lower the other one for me to get my hands in there.

I used a few floor jacks to lower them to the ground. And made sure they had very little gas in them at the time.

Good luck installing yours.

Ron.

Share this post


Link to post
Share on other sites

Ron,

I figured I would have to drop the gas tank , etc. to mount my wheel chocks. I was hoping someone might have a better way though.

SMarquez,

I see your Fire & Police avatar. I raced Glen Helen F & P in 2007 and the New York round in 2006. I race the F & P Benefit every June and I promote the Ohio P & F Games MX every year as well.

The floor and wall trailer screws , do you drill a small hole first or do they drill thru on their own. Either way without a nut on the other end would they be able to hold down a wheel chock let alone a tie down ring with lots of pressure pulling on it ?

Thanks guys for your replies !!!

Share this post


Link to post
Share on other sites

Ron,

I figured I would have to drop the gas tank , etc. to mount my wheel chocks. I was hoping someone might have a better way though.

SMarquez,

I see your Fire & Police avatar. I raced Glen Helen F & P in 2007 and the New York round in 2006. I race the F & P Benefit every June and I promote the Ohio P & F Games MX every year as well.

The floor and wall trailer screws , do you drill a small hole first or do they drill thru on their own. Either way without a nut on the other end would they be able to hold down a wheel chock let alone a tie down ring with lots of pressure pulling on it ?

Thanks guys for your replies !!!

Good to hear from you. We are laying off for the summer, back to Comp Edge in September. Yes, you need to drill a pilot hole to run the screws in but they stay put. I think I used a #7 drill bit and they went right in. I put a couple Pingle type chocks in my weekend warriior and the havn't loosened. like I said, thats what the deck is fastened to the frame with.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0