HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
joeygmx

need advice 2011 YZ450 linkage rebuild

2 posts in this topic

The connecting rod has a hole bored though with a counter bore on each end that is sized to press fit the bearing(outer race). The race is press tight to the bottom of the counter bore. The through hole is the same diameter as the inside diameter of the race. This makes the race pressed in "blind".

Does anyone know an easy way to properly remove these. I have cut off races before with a die grinder but that's not an option in this case. I'm thinking a Blind Hole Bearing Puller with a little heat applied. Any suggestions would be greatly appreciated.

thanx

joey

Share this post


Link to post
Share on other sites

I'm thinking a Blind Hole Bearing Puller with a little heat applied.

:thumbsup:

1 person likes this

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0