Sign in to follow this  
Followers 0
qwert321

08 yz450 stator?

3 posts in this topic

I had one of the small screws(the four in between the windings in picture) holding staor to plate come out and wreck my stator and flywheel.My question is can I remove these bolts one at a time and locktite them on my new stator and not do any damage to windings.I want to do this as the other three screws where loose also.

esl387.jpg

Share this post


Link to post
Share on other sites

I doubt taking one out at a time will loosen the windings. If your worried about that then just use a g-clamp on each side as you unscrew the bolt.

Share this post


Link to post
Share on other sites

I ended up doing it one screw at at time and the stator still worked so all is good.I dont know why they dont locktite it from factory.$525 dollars because of no locktite, atleast the new stator and flywheel was a upgraded part.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0