Brake Help after bleeding

On my 09450 I installed a brake light switch, replacing the banjo bolt on the rear master cylinder. The rear brake still worked after install, but I decided to bleed it anyway. I used a syringe and back bled the line. After I got done there is no brakes at all, ie pedal dose not engage the brake, even after pumping several times.

Any suggestions?

Thanks

Nevermind, got it figured out. Had air trapped by the banjo fitting.

Thx

:ride:

Nevermind, got it figured out. Had air trapped by the banjo fitting.

Thx

I had an Aprilia that you needed to take all of the parts off of the bike and turn them upside down, sideways, stand on your head and sing a special chant to Itally to get all of the air out. Thankfully these aren't that bad!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now