Sign in to follow this  
Followers 0
RCJIM

Installing lights on a 2002 yz426

5 posts in this topic

Anyone here done this, i heard that the yz uses the same wire harness as the wr so there should be a place near the bars to hook the lights into, do the yz and wr use the same stater, etc..

Share this post


Link to post
Share on other sites

You heard wrong. The YZF and WR use two different complete electrical systems, stators, flywheels, etc. The YZF stator will not drive lights of any kind, and in order to use a WR stator with a YZF CDI, the stator has to be rewired.

The WR parts do fit the YZ, however.

Share this post


Link to post
Share on other sites

Gray, when you say rewired, what do you mean?

I am putting a WR stator and flywheel in my yz426f, and after doing research on here, i found all that was needed was to float the pink wire.. Is this not correct?

Share this post


Link to post
Share on other sites
Gray, when you say rewired, what do you mean?

I am putting a WR stator and flywheel in my yz426f, and after doing research on here, i found all that was needed was to float the pink wire.. Is this not correct?

That is the rewiring that's needed. Not rewinding, just a minor bit of rewiring.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0