HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
sjnorton

08 WR 450 Hard Starting

3 posts in this topic

My bike is only a couple of months old; all I have done to it is remove the restrictive baffle from the stock exhaust ; Anyhow when cold my bike will start just fine with the choke pulled; the problem is that once it is good and warmed up it still will not start unless the choke is pulled;

This is a huge problem at the start of a hare scramble; yesterday i was the last person to leave the line; i had to kick start the bike

Once the bike is real hot like when i stall it during the race; it will start with out pulling the choke; but it takes several (2-3) seconds of pushing the button to start.

Is this a jetting problem; the bike has done this since new (3-months old)

Share this post


Link to post
Share on other sites

Fuel Screw/Pilot Jet

Fuel screw settings in the 'book' are recommended starting points. Every bike is different, as is the temp and altitude. Set the screw according to this method.

Gently turn the screw all the way in. Now back it out two turns. Start the bike and fully warm it up, go for a 10 minute ride. Set the idle to speed to 1,500~1,800 RPM as best you can (I know, without a tach this is tough, just set it to were it idles relatively smoothly). Once warmed, slow the idle to the lowest possible speed.

*** When turning the fuel screw, keep an accurate 'count' of the amount you are turning it and record it in case you have to reset it for some reason. Makes life easier when you can just set it from notes Vs. going through the procedure again.***

Turn the screw in until the idle becomes rough or the bike stalls.

if it stalled, open the screw about 1/4 more turn. Restart it and slowly screw it in till you can just perceive a change.

If the screw can be turned all the way in and the bike still idles perfectly and does not stall, then you need to go down a size in pilot jet.

Now very slowly, open the fuel screw till the idle is smooth. Blip the throttle, let the bike return to an idle, wait say ten seconds. Confirm it is the same smooth idle.

If the screw has to be opened more than 3 turns to get a smooth idle, you need to go up a size in pilot jet.

If you find it does not stall with the larger jet but has to be open more than three turns with the smaller pilot jet, put the larger one in and set the fuel screw at 1/2 turn.

If the idle speed increased, adjust the idle speed knob to return the bike to a real slow idle speed. You must then re-visit the fuel screw. Keep doing this till the fuel screw is opened just enough to provide a nice steady idle at the lowest possible RPM. Once this is done, increase the idle speed to the normal one for your bike, typically about 1,800 rpm, but go by the spec in your manual.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0