Sign in to follow this  
Followers 0
slider91129

Baja designs brake light switch

2 posts in this topic

I have a brake light switch installed in my rear master cylinder where do I wire/splice in from?

Thanks,

Jay

Share this post


Link to post
Share on other sites

Your stock tail light runs continously. On the stock wiring harness to the tail light, (splice, don't cut) take the hot (12v) to the BD switch. The other wire on the BD switch will need to be spliced to the second wire on the tail light wiring harnes. The harness from the bike has only two wires, 12v pos and neg. The tail light has 3 wires, Constant 12v (running), switched 12v(brake) and the negative(ground) wire. Even though it's connected to the plug, The second wire on the tail light is not being used.

Pretty simple job, shouldn't take more than half an hour assuming you have all the splices and extra wire.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0