08 yz450 PMB Spark Arrestor Pics

Installed today. Now I'm legal! Didnt see any pics with it on a bike when I was looking to buy. Hope this helps others. Used a drill press with a step bit to drill out the existing rivets. Used a vice to remove the stock end tip. Used a hand drill for the new pop rivets. Easy install. Sounds and looks good.

2008_1227_151313AA.jpg

2008_1227_151250AA.jpg

2008_1227_120137AA.jpg

Looks good, thanks for posting the pics. Notice any power loss or sound reduction?

I have one on my 08 YZ exhaust on my 07 WR. I found power output to be about the same with a different sound but similar DB noise. Test around 97-98db. I run mine with the silent insert to pass the 96db at races. Come in just under 96. Silent insert seems to smooth the power out a bit with maybe a small loss.

P1010252.jpg

One thing to add. That shot is from June. The andonizing on the endcap is now a dull grey. No biggy if you don't worry about the bling factor. I only clean with straight water so I figure it is either from heat from the exhaust or our mud is really acidic ??:busted:

Looks good, thanks for posting the pics. Notice any power loss or sound reduction?

Havent had a chance to ride, just idle in the driveway. Its not louder but did notice a "flutter" sound at low rpms. tribalbc said it well " different sound but similar DB noise"

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now