HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
TeamScream

Removing stem from lower triple clamp?

2 posts in this topic

Is the hole in the lower triple clamp where the stem presses in tapered? or is it just a standard through hole? I need to press my stem out for some work and possible replacement of the lower triple clamp and I want to do it the right way. Thanks!

Share this post


Link to post
Share on other sites

If I remember, it is not tapered, but it doesn't matter. There is only one way to press the stem out or in. Support the bottom of the clamp (around but not under the stem) and press down on the top of the stem. This will press the stem out of the bearing and clamp at the same time. When pressing in, flip it over and support the bearing. Press the bottom of the stem down into the clamp and bearing at the same time. Be careful not to gouge the stem.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0