Sign in to follow this  
Followers 0
deano0

header pipe

4 posts in this topic

I am thinking to take off my header pipe and clean it to get it looking A1 condition. if i take it off do i need to use any exhaust glue or cement when i put it bak on to the engine?? my one at the moment looks lyk it has got some sort of glue or silastic on it??? and pointers???

thanks guyss!!!!:applause: :applause:

Share this post


Link to post
Share on other sites
if i take it off do i need to use any exhaust glue or cement when i put it bak on to the engine??

No glue or cement required. Just give it a good cleaning and stick it back on. :thumbsup:

Share this post


Link to post
Share on other sites

Not necessary on the cylinder side

But I do use high temp Gasket/sealer by Permenex on the header to rear cannister junction for all aftermkt pipes/header to keep it airtight:thumbsup:

Share this post


Link to post
Share on other sites

well the pipe is off now, looking really good.. cumming up better than i expected. i cleand the surface that goes into the engine so it should seal up nicely

thanks for that boys

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0