HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
Dougie

What is proper procedure to check float bowl?

1 post in this topic

If I am not mistaken, the float bowl level should be set at 9mm. However, I'm not exactly sure how to check it. Flipping the carb all over, I can get a reading of 9mm. But I'm not sure how far to flip it.

Here's how I did it Friday...turned carb all the way upside down. Slowly tilted back towrards upright position. The bowl started to fall out and it kind of stopped before falling all the way out. I measured where it kind of stopped and it was 9mm. But when it falls all the way out, that little tab is still touching that little tip. Is this correct?

Thanks, Doug

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0