Sign in to follow this  
Followers 0
Guest Guest

Shock removal

8 posts in this topic

Does anyone have any tips on how to remove the rear shock? I am replacing the spring so any help would be appreciated.

Angel Boy

Share this post


Link to post
Share on other sites

I know that there are two bolts holding the shock on. One is at the top and the other is at the bottem. I don't know how to remove it. Do I need to take the swingarm off or should I take the rear subframe off?

Angel Boy

Share this post


Link to post
Share on other sites

Take off the rear master cylindar guard too. It will scratch the paint on the subframe if you don't.

Share this post


Link to post
Share on other sites

Well that was a lot of information. Too awsome that so much information is available. Thank You. Shock is already done. I removed tank, seat, exhuast, and side panels. Loosened carb boot and removed top subframe bolt and loosened the bottem subframe bolts. I then bent the subframe down, and pulled the shock out of the top. One thing I didn't expect was that a spring compressor is needed in order to remove the spring. Oh well, its done and only 1 to 2 months till I will be healed enough to push the suspension to see if the springs were worth replacing. Thanks for everyones help.

Angel Boy

Share this post


Link to post
Share on other sites

Angel-

1.) Remove the bottom shock bolt on the linkage. 2.) Remove bottom subframe bolts and loosen the top after removing the seat (maybe tank too). 3.) Loosen the air intake clamp on the carb all the way 4.) Raise subframe up 5.) Remove the top shock bolt and it comes right out. While your there, seal the clean side of the airbox flange with hondabond4 and inspect the top shock bolt mount for cracks (not that the WR is known for this, but a smart idea. If the shock bolts are pitted or distorted in any way, replace them w/ OEM stuff.

If you haven't done any linkage/swingarm maintenance in awhile,do that too. It's not very hard-just be careful and use a torque wrench. Good luck, you'll be fine.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0