Sign in to follow this  
Followers 0

New handlebar issue..worth a read..

3 posts in this topic

So after installing new bars on my 650, the engine would quit if you turned the bars to the right, spent a good 20 minutes trying to figure it out thinking electrical short somewhere, disconnected GPS /Headlight Kill switch, turns out I did not put the clutch handle where it needed to be on the bar, had it about an inch or two too far out, and when turning the bars to the right it was pulling on my decomp cable. Nice.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0