HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
Bill

How to set the idle speed...Properly!

7 posts in this topic

Is there a meter I can buy or is one of those whirly gig thingamagigs you lay on the bike and try to get the needle to spin in a circle, ok?

Also what is the proper idle speed. Yeah I know, it's in the manual :):D:D

Bill

[ February 09, 2002: Message edited by: Bill ]

Share this post


Link to post
Share on other sites

I have the 01 WR426 and I don't know if the settings are exactly the same for your bike. To check what the RPM's of the 01, you need an inductive tachometer. Yamaha has one which is listed in the 01 manual as PN YU-08036-B. The specs for the 01 model says that the idle speed should be 1700-1900 RPM. Hope this helps.

Share this post


Link to post
Share on other sites

I've found that using a Digitron Race Kart inductive tach to work well. Also if needed, you can mount it to the crossbar for tests while under riding conditions.

PK

Share this post


Link to post
Share on other sites

bill

down near the end of "jetting Q's" i went to 55PAJ/35PJ and the idle went so high i had to turn the knob out a full turn (1mm) to get the revs back down. i know it's creating a mountain out of a mole hill but there you are!

Taffy

Share this post


Link to post
Share on other sites

Mike,

I was going to mess with the jetting and wanted to make sure I had some idea and/or the correct idle speed.

Then start with the idle>>pilot ciruit and go from there.

Bill

Share this post


Link to post
Share on other sites

Bill

Are you looking for one to permanently attach so you can view RPM's while riding? Or just want one for testing? I would steer away from a permanent one...I find if almost impossible to check the panoram when I'm riding...those trees come up too quickly to look down :)

Idle speed is indeed 1700-1900 rpms. That's a big range!

Dude I would just set it so it doesn't stall when you release the clutch slowly in first. It should pull and your butt on a flatsurface w/o stalling, yet not be so high that it's affecting the rear wheel braking effect.

I also turn it up a little in deep mud to avoid stalling from the extra weight glued to the bike. If I rode in sand a lot I would probably have a higher idle than dirt, too.

To each his own, though! Good luck, Bill!

Share this post


Link to post
Share on other sites

In that case, Bill...warm the bike up, then set the idle so the bike is on the verge of stalling.

Now play with the fuel screw/pilot jet. You'll want to set it at the low idle setting and listen carefully for the engine to smooth out or cut out. Leave at teh smothest setting, then turn idle up and go ride.

It's easier to hear an improvement when the idle is turned down. Listen for the mechanical noise, not the exhaust.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0