clarke 4.0 tank install question (foam?)

Good Morning,

Received the clakre 4.0 tank and am going to install it today on my xr650l.

Question - Where does the foam go? Do I wrap the frame by the front mounts or near the rear bolt, or along the whole ridge?

thanks in advance,

JT

Good Morning,

Received the clakre 4.0 tank and am going to install it today on my xr650l.

Question - Where does the foam go? Do I wrap the frame by the front mounts or near the rear bolt, or along the whole ridge?

thanks in advance,

JT

Basically it's wrapped lengthwise around the top tube between the mounts & rear bolt flange. Just dry fit the tank & you'll see the best location to strap the high heat foam on the frame in relation to the tank saddle. Electrical tape works to set the foam in place first, but also use some zip ties to secure it after using a few bands of tape.

thanks for the reply dd.

where did you get the tank graphic/decal you have on your bike?

JT

Thanks for the info, I just ordered mine and it should be here in a day or two :ride:. You saved me from having to ask :ride:

thanks for the reply dd.

where did you get the tank graphic/decal you have on your bike?

JT

That was a package of older stlyle CR graphics from One Industries I picked up from a local cycle shop here in So Cal.

Tank installed and driving range increased.

It fits really well and very secure.

Thanks,

JT

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now