HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
joshbeene

Does 05 WR still have grey wire to cut?

12 posts in this topic

I had a 2002 WR426, and now I have the 2005, and don't know if you still have to cut the grey wire. Where is the grew wire located if I do need to cut it? I have my 05 WR450 Street legal in California so I am not doing to bad in that department, but I don't know about the grey wire thing.

Share this post


Link to post
Share on other sites

Yes it does. I did it to mine. The harness is located under the seat.

Share this post


Link to post
Share on other sites
The harness is located under the seat.

:thumbsup::thumbsup::bonk:

They've always been under the tank along the frame.

You have to pull the seat to get there, but that's where it's been.

Share this post


Link to post
Share on other sites

I did did both my 426 and 450, yep yep....both under the tank :thumbsup:

Share this post


Link to post
Share on other sites
I did did both my 426 and 450, yep yep....both under the tank :bonk:

:bonk: Depends where you cut it! Where does the wire come from :thumbsup::thumbsup:

Share this post


Link to post
Share on other sites
:bonk: Depends where you cut it! Where does the wire come from :thumbsup::thumbsup:

CDI... in front of the tank on the stem. I'm not sure where it goes, because it's only connected to a logic ground.

Share this post


Link to post
Share on other sites
I was being sarcastic..............

No way....that's so out of character for you :thumbsup:

Share this post


Link to post
Share on other sites

Yes it does, but don't cut it just unplug it. The coupling looks like there are several areas holding it it, but if you look close the side towards the front is actually more in the middle and is only held by one clip. It pops right out. Simply unplug the coupling, and then use a awl or small screw driver to release the pin. When you look down inside the pin you will see a small plastic clip holding it in. It looks like you should push the plastic towards the pin, but actually pry it away from the pin and pull on the wire. It will slide right out including the seal. I then used silicone after plugging it back in because it will get pushed out as you plug it back in due to a air tight plug. Tape up the grey wire and you are good to go.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0