Sure Blue, kind of weird to tear apart a brand new bike but it's the best time to do it. I was wondering how much grease was on the bearings from the factory? Also, why did you use the 175 main when most are using the 170 main? I'm just curious if you have had any experiences that caused you to use it rather than the smaller 170. Are the ProSeal air filter seal the magnetic drain plug the same as the 03-05's or is it specific to the 06's? One other thing is I used the TM design slider on my 03 450 and it made so much noise, I took it off and use automotive goop with some coarse foam under the stock slider to prevent the chaffing. I had used them previously with great luck but I think when they changed the design to where you could install it without pulling the swingarm, I think it made it no better than the stock one since it moves around more than the prior design. Doc Fletcher, can a chiropractor do work on himself? You must be in demand at the track. The bike is looking good, no unnecessary bling to make it look excessively bling'd, very tasteful application of the bling. There's some other threads concerning the low amount of grease. What ANY MX rider should do as SOON as they get their bike home is a complete tear down minus removing the frame. The grease is a joke on the bikes new. You need to make sure you grease EVERYTHING! Steering head, axles, shifter and brake bolts, swing arm bolt, rear shock linkage bolts, etc. DO IT! DO IT NOW!