Vortex ignition???

I am getting ready to install a Vortex Ign on my 03 wr450. I have the grey wire mod done. Will this effect the ign??

No. Have fun with the traction setting!

No. Have fun with the traction setting!

:thumbsup::bonk: :confused:I thought Matty said they were great.

They are great!

:thumbsup::bonk: :confused:I thought Matty said they were great.

I was complimenting the vortex ignition's traction setting mode. :thumbsup:

where can I find out about this grey wire mod I want to do this to my WR 450 05 & how much difference does it make.

where can I find out about this grey wire mod I want to do this to my WR 450 05 & how much difference does it make.

ooohhh tricky one ....dont think theres ANY info available in the search on that one :thumbsup:

where can I find out about this grey wire mod I want to do this to my WR 450 05 & how much difference does it make.

Only because your Aussie.......

Yeah mate, it is the grey wire coming off the ignition module on the 6 pin connector. It is in the middle of the connector, it is actually the ground wire.

You have to take off your tank to see it. Just pull it out of the connector with long nose pliers, that way you can put it back in later on if you want to. Just wrap the loose wire end with electrical tape.

It does make a bit of a difference, it advances the spark to YZ ignition timing, which adds a little bit of power to the mid - top end. No loss in bottom.

Vortex ignition way better if you are wanting to know.......

Have fun cobber!

how to i adjust the vortex on a wr450 please

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now