HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
dirttrack25

BK Mod

5 posts in this topic

What tool are needed for BK mod what size drill bit an tap

Oooh.

I forget. Did you do a search.

I want to say I used a 5mm screw. I also used the same spring off the timing set screw (by the pulley).

So you need the drill (usually if you buy a single tap it will tell you what size drill bit), bit, tap, screw, and the spring.

Hope this helps.

Share this post


Link to post
Share on other sites

I used a 6-32 screw and tap. I think that it was a 3/8" drill bit I used. I don't quite remeber but I used calipers to find a bit smaller than the tap. But as you heard, the tap usually says what bit to use. Did it all in about 15 minutes.

Share this post


Link to post
Share on other sites

I did a search but I only found the tap size and screw size I didnt know what bit i should use. Hopefully when i buy the tap itll say what bit to use. Thanks

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0