Sign in to follow this  
Followers 0
tshe1

need help of resque clip

5 posts in this topic

while installing the cams and the timing chain, the clip of the cam (clip that locating the bearing of the cam in the camshaft cap) fell into the crank, under the sprocket of timing chain and crank.

I'm scared to death. how can i get it out?

I've try with small magnet but their is no enough space their.

i just finished to install the head, can it help to remove it again and the chain slider?

can i use the head gasket again? (just finished to tighten the head, the engine didn't run yet).

can it help to tilt the bike and try to bring it out while the bike tilting?

how far it takes to insure that the clip can come out? (how far with parting:remove the rotor...??)

Share this post


Link to post
Share on other sites

Take off the side cover on the timeing chain side. Your clip should be in that side of the case some where. You might have to remove the flywheel....

Share this post


Link to post
Share on other sites
Take off the side cover on the timeing chain side. Your clip should be in that side of the case some where. You might have to remove the flywheel....

yes, my guess was that it should remove.

according to the manual the cover,flywheel,and magneto have to be remove.

what it takes to remove those parts? (do i really need special tools).

is it difficult to assembly them back?

Share this post


Link to post
Share on other sites

got the side cover off to part the rotor and stator.

i was Lucky, get off the cover and see the clip in small gap between the rotor and stator.

pull it easy with the magnet. end of story, Lucky me.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0