I have the baja design kit. I had removed it from the bike (not entirely) to do some maintenance during the winter. I had re-installed it and had two problems. I just re-installed it with the manual to make sure everything is plugged OK but it did not get rid of the problems. Problems are: First problem: can't stop it: either gray button or light switch won't kill then engine. here is the kind of switch I have on the bike : The gray button never worked... when I bought the bike used, this button was inoperative. I don't know if the light trick is standard but when I bought the bike, ithe baja kit was installed so that the light switch needs to be on in order to get the bike started. Since I have the bike, I shut it down by switching the lights off (it worked good till last fall). Second problem: flashers don't work, neither at the back or the front. Not only they don't blink, they don't even light up. I'm sure every wires are plugged OK. The bike fires very very easily and revs very smoothly. Front light works as it should. Rear light including brake switch work fine. Can the handle bar switch be down? The last time I messed with this kit, I had no response at the tail light when pushing on the rear brakes. After changing the light and verifying all connections, it turned out that the switch ( the one that mounts on the rear brake cylinder) was dead. Now I think the switch on the handle bar is responsible for those problems. What do you think? Thanks for your input.