HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
ridger

yz cam and jetting

2 posts in this topic

I just ordered my yz cam. Then for the fun headed up into the desert, there was a little bit of mud and snow but other than that conditions were xcellent!! The bike was fantastic, it ate those whoops and that sand alive. When I get this cam in can I expect any jetting changes. My elevation here is around 5000ft. Thanks for the help.

04wr450, gpr, pro tapers.,power now,michelen m-12s

Share this post


Link to post
Share on other sites

keep a close check on left side exhaust valve bucket. the yz decompresion pin eat my valve bucket up. the yz pin was longer than the wr stock. i installed the wr pin in the yz cam. i dont have any results back yet on wear. but i may have had a bad part from the start. our local dealer is sending a message to yamaha about this problem.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0