Jump to content

AIS Again and Again Question?


Recommended Posts

I'm ordering the lowedag kit for the AIS system but I am going out for some rides before I get it and was wondering what your guys opinions would be on a thought I had to fix it temporarily. I was thinking of cutting the tube that goes from the AIS pump to the front of the exhaust port tube in half and getting a two sided plug of sorts and then placing it inside the ends of the tube that was cut and clamping the hose down on the plug on the both ends. I was thinkinhg that this plug would basically do the same thing as lowedogs kit without the nice clean look of throwing that piece of $h!t away. What are the opinions of the residing gurus on this site about this Ghetto Fix?

Link to comment
Share on other sites

If you are going for a low $ fix, it may work to just remove (and plug) the small vacuum line that feeds the unit. Without this, it wouldnt be pumping any air (since the vacuum powers the unit). ?

But I have not tested this...just a theory... I ordered Lowedogs kit... looks very clean, I will be installing it this weekend. ?

Link to comment
Share on other sites

Take the tube off the 90 on the front of the cyl.(exh. side) and tap it with an 1/8 inch pipe thread tap. Plug it with an 1/8 inch pipe plug and use pipe thread compound.Use a 1/8 inch vacuum cap on carb side of cylinder.And use a 1/2 vacuum cap on the 90 coming out of the airbox.I bought this all at napa very cheap,worked great.

Link to comment
Share on other sites

FYI, Istill plan on getting lowedogs kit but in the mean time I took a two sided bolt and put it between the tube going from the pump to the exhaust port, I cut the tude in half and threaded the bolt into both sides and zip-tied it on both sides. The Ghetto Fix(trade marked) worked pefectly, I just jetted yesterday and the bike ran way better and now that I have done this I have no backfire issues at all.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

×
×
  • Create New...