I just installed the Rekluse unit on my '03 YZ450F. I confirmed the gap to be just slightly greater than 0.76mm. However, after following the break-in instructions, I still cannot get it to work properly. With the bike on a stand, I shift into first, apply the rear brake and the bike will stall. Off the stand, if I am in neutral and shift into first, the bike will stall. I noticed that the clutch actuator arm is rotated as far as it can go towards the external adjuster bolt. In this position, there is little to no spring tension. I do not hear any scraping on the inside of the clutch cover, so I don't think that is the problem. Any ideas? Thanks you in advance.