Sign in to follow this  
Followers 0
Kilroy Was Here

WR hydraulic rear brake light switch...

3 posts in this topic

OK guys, have a 2001 WR 426F and will be ordering a brake light switch for the rear master cylinder. My question is, what is the thread pitch on the banjo bolt, my choice is 1 of 2, I want to get the correct one. Thanks! :)

Share this post


Link to post
Share on other sites

you need the coarser thread one, "10mm x 1.25mm" i think it is referred to as.

Jim, thats what I was looking for. Yes, I knew it was either 10X1.0 or 10X1.25. I will order it tomorrow. I just ordered an LED rear type 1157 bulb today. This should keep the brake light bright without sapping too much current from the headlamp! Thanks again Jim :)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0