03 wr450f clutch problem continued

I replaced the clutch cable and clutch plates and when put back together, as I put the bike into first the bike launches forward and stalls. I did not replace the clutch springs so idk if that could be my problem?

Did you coat all the clutch frictions in oil when you put it back together?

I replaced the clutch cable and clutch plates and when put back together, as I put the bike into first the bike launches forward and stalls. I did not replace the clutch springs so idk if that could be my problem?

 

Whose cable, whose plates did you use.

Did you replace fibers and steels.

Did you clean up the basket notches.

 

All WR clutches drag, espeically cold.

Did you coat all the clutch frictions in oil when you put it back together?

Yes I did

Whose cable, whose plates did you use.

Did you replace fibers and steels.

Did you clean up the basket notches.

All WR clutches drag, espeically cold.

Cable was motion pro and plates tusk and I did replace fibers and steels. The basket notches didn't look bad so I didn't touch them. I let the bike run for a little bit and I still couldn't put the bike into gear without it stalling every time.

Tusk plates are junk.

^ that

 

The Tusk plates and fibers are 'thicker' than stock, making your disengagement problem worse than before....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now