HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
danpat1508

Waterpump bearing and shaft freeplay

3 posts in this topic

Hi,iknow this topic has been done to death but I haven't been able to find the answers im looking for.

Just replaced the seals in the waterpump and was wondering when installing the bearing if it sits flush where it sits? Or just below the lip of the case surface?

Also wondering if when the seals, bearings, shaft and impeller are back in place. Should there be any in and out movement?

Thanks again.

Share this post


Link to post
Share on other sites

just done mine

bearings sits flush with c/case cover (or as near as)

yes there is in & out float of the shaft (about 2-3mm)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0