08 yz450 petcock nipple

went twist the hose off and hole nipple came out. Anyone with success tapping it back in reliably? This is my mx bike

Yes

Put some JB Weld on it afterwards

Use a small round brass brush (gun shop) to spruce up the bore, and some fairly coarse sand paper to rough up the hose barb, then insert the barb part way into the bore. Apply a bit of JB or other two part epoxy at that point and drive the fitting the rest of the way in.  Give it two full days to cure. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now