Rebuilding 426

[Clutchup]

Whats up guys finally got my wr gears in my yz and also put a new piston and just today it randomly seized on me so im thinking the piston is shot and cylinder. Where is the cheapest place to buy a new cylinder? I checked thumpertalk and it was like $500? I check another website and was $250. Anyone know of a good site with the lowest prices? Btw i did not get my cyclinder re plated when i put the bew piston in could that of caused a seize? Once it cools down the seize gets loose and i can start again then will run then lock up again and cant kick threw.

[Clutchup]

ok ripped the motor apart and I think the connecting rod roller bearing went bad causing the pistion to hit the walls. well I made a video to show you guys and tell me what should I do I seen connecting rod rebuild kits should I do that or can I just get a new bearing?

 

https://www.dropbox.com/s/k1w2p1wyf73koiy/Video%20May%2025%2C%208%2055%2054%20PM.mov?dl=0

[grayracer513]

Either buy the rod, bearing, and crank pin, send to a shop for a rebuild, or buy a complete new crank.  The money is close to the same either way.

[Clutchup]

Gray racer when i buy a new jug is the cylinder ready to go plated and hatched? What are good low price websites to buy oem parts i seen the price for a jug from $300 to $288

[grayracer513]

New cylinders are ready to use.  Yours can probably be replated for less than the price of new.

[Clutchup]

Yeah mine got chewed up tho pretty deep scratches

[grayracer513]

Can still be refinished, nevertheless.  Contact Millennium Technologies. 

[Clutchup]

Im just gona go new and replace all thanks for the help