HEADS UP!!!

Site upgrade in progress... Core site functions are working, but some non-critical features/functions will be temporarily unavailable while we work to restore them over the next couple of weeks.

Please post any bugs you encounter, but before you do, check to see if it's already listed.

Thanks for your patience while we work to improve the community.

Sign in to follow this  
Followers 0
Hurst62

oil flow?

6 posts in this topic

Hey guys....I've got an 06 wr450. Just had the top and bottom end rebuilt. Fired it up about a week ago and it makes more noise than it did before the rebuild.Is that normal? Was going to take it out tomorrow but with all the clatter.....I'm a bit nervous!!

Share this post


Link to post
Share on other sites

if your valves were zero'd out before and they have proper clearance now, then they will be louder.  OR something could have been done wrong and it's going to explode.  Hard to tell over the forums.

Share this post


Link to post
Share on other sites

Rebuilt as in new crank bearings, pin, connecting rod, piston, rings, and pin. I loosened the bolt and waited to oil flowed out but didn't actually check the pressure

Share this post


Link to post
Share on other sites

Rebuilt as in new crank bearings, pin, connecting rod, piston, rings, and pin. I loosened the bolt and waited to oil flowed out but didn't actually check the pressure

 

So no cam chain, chain tensioner, or anything in the head ??

Share this post


Link to post
Share on other sites

Yes...new can chain. Everything in head was fine. Valves were in spec and didn't require reshimming

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0