Advice about Forgotten Dowel pin WR450


4 replies to this topic
  • hafte

Posted December 28, 2012 - 08:13 AM

#1

Hi All,

I have one quick question.
When i join my WR450 bottom end, I was installed the o-ring (with small amount of liquid gasket) between to cases, but forgot to put dowel pin. The oil pressure is low, and feed only oil thank in the frame.

Posted Image

I will be a problem?

  • hafte

Posted December 29, 2012 - 11:01 PM

#2

I was split engine again and solve the problem.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • JDLowrance

Posted December 29, 2012 - 11:13 PM

#3

Good idea as without the dowel pin there is no guarantee the o-ring will seal.

  • MANIAC998

Posted December 30, 2012 - 05:07 AM

#4

I know it's alot of work, but that is what needed to be done. You need that oil going where it's designed to go!!!

  • hafte

Posted December 30, 2012 - 05:26 AM

#5

It is not so much work. It took me 4 hours to split and join all :-), but it was for good, i hope.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.