Zip ty hot start install help!

No replies to this topic
  • surveydude

Posted November 14, 2012 - 08:11 AM


After a (long) complete top and bottom re-build on my 99 wr400/ now 426 my machinist had hooked up my acv/carb lines bypassing my hot start. I have the 1999 model without the red button and did enough research to know I have a after market zip ty bar mount system with acv valve. Question is where do the vacuum lines go (pictures would be of great help here) to properly install acv and hot start? BTW bike is running tip top and is EASY to start and have never had to use a hot start button before. However it must have been installed by the previous owner for a reason and seems like a waste not to re-install.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.