2006 to 2012 triple clamp swap


1 reply to this topic
  • ogrione

Posted October 28, 2012 - 02:47 PM

#1

Hello there,

I was wondering if anyone has swapped out a 2006 to 2012 triple clamp....I have taken measurements and found that the 2006 is 19.5cm, whereas the 2012 is 19cm. Can I press out the steering stem and swap between the two.....they look identical execpt for the length?

Thanks,

Andy

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted October 29, 2012 - 06:37 AM

#2

The '06 clamps are a 25mm offset, while the '10 and up are offset 22mm. I don't think you'd like the effect on handling, but you can decide that, I suppose. You'll also give up the additional optional bar positions.

Check the width difference, if any, also.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.