2011 wr450 wire connectors


2 replies to this topic
  • medicman

Posted October 24, 2012 - 03:29 PM

#1

So aim trying to remove the subframe on my bike, the wire connectors are a pain. Is there a special tool to push both pins in at the same time or do you just have to be very coordinated


Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • MANIAC998

Posted October 24, 2012 - 06:04 PM

#2

You can get them by hand. Sometimes it helps to push the connector together before pulling them apart. This allows the little pin that's holding them together a chance to dis-engage. When you go to put them back together, use dielectric grease, and you won't believe how easily you can remove them the next time!!! :thumbsup:

  • William1

Posted October 25, 2012 - 08:58 AM

#3

I often use a jewelers screw driver to press the tab in too.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.