2012 Throttle stop screw


5 replies to this topic
  • Grover9876

Posted August 24, 2012 - 06:13 PM

#1

I am having trouble getting my big ass mitts to the throttle stop screw and removing it. Lets hear how you guys removed it.

Thanks.

  • supermega1

Posted August 25, 2012 - 10:02 AM

#2

I took the header and the exhaust off and used one of these:
Posted Image

  • xXNewfie709Xx

Posted August 25, 2012 - 04:18 PM

#3

Same here. Took the header and the exhaust off and used a jack stand to raise my bike up high.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • tomerb

Posted August 25, 2012 - 07:56 PM

#4

I took the header and the exhaust off and used one of these:
Posted Image




How did you get the tamper proof torx out with a flat tip and a phillip's??

  • supermega1

Posted August 28, 2012 - 12:12 PM

#5

How did you get the tamper proof torx out with a flat tip and a phillip's??


I have a tamper proof torx set like this that I put in there:
http://www.harborfre...-set-68457.html

Posted Image

  • 123honus

Posted September 10, 2012 - 05:54 AM

#6

If I remember correctly, it is a T27 torx.
I did not put back in a Torx, I inserted in an allen head. It was easier to install.
You can get it out the left side of the pipe, but it is easier to take off the header and muffler.
At least it was easier for me. I tried them both.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.