Need HELP!


3 replies to this topic
  • 11WR450

Posted July 05, 2012 - 03:28 PM

#1

Today I was installing my GYTR AIS kit and when installing the block off plate i had to loosen up the clamp that holds the coolant hose right by the allen bolt for block off plate. when trying to slide up the coolant hose it popped up and some coolant spilled, And I think some went in the partially open hole for the AIS port.? If that did happen am I up sh#t creek? Or can i just change the oil and flush it out that way? Thanks

  • 11WR450

Posted July 05, 2012 - 05:20 PM

#2

Anyone?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • n16ht5

Posted July 05, 2012 - 05:40 PM

#3

little confused on how coolant got in your oil .. how much coolant went where?

  • 11WR450

Posted July 05, 2012 - 05:58 PM

#4

Well not oil. Concerned that coolant went down into the AIS port.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.