carb float adjusting a 2 stroke how to ?


2 replies to this topic
  • motomonster360

Posted June 21, 2012 - 09:20 PM

#1

alrite so i got the service manual as many of you suggested i did i read throw it very usefull but when it came to adjusting the float level is told me to use a special tool and was very vague about the hole process, and talked about bending the tab on the return back, im still at a loss of how to adjust the float on my 03 cr250. any help greatly appreciated

thanks to everyone who has helped already.

  • KcDavis

Posted June 21, 2012 - 10:09 PM

#2

Have you checked youtube?

  • motomonster360

Posted June 25, 2012 - 05:30 PM

#3

not a single reply !!! ya i checked youtube, i guess im just not understanding the concept behond the hole thing, if im over flowing with gas i would bend the rebound tab up more ?





Related Content

Forums
Photo

1999 CR125R Choke installation? by josephduckworth


Dirt Bike   Make / Model Specific   Honda   Honda 2-Stroke
  • 1 reply
Forums
Photo

2007 CR250 IDLE AND LOW RPM PROBLEMS by Speeddemon73


Dirt Bike   Make / Model Specific   Honda   Honda 2-Stroke
  • Hot  33 replies
Forums
Photo

How can I determine if a 2002 CR250 motor will fit, with slight mods, into a 1995 CR250 frame? by 5th gear tapped wide


Dirt Bike   Make / Model Specific   Honda   Honda 2-Stroke
  • 3 replies
Forums
Photo

99 Cr125r not running correctly by josephduckworth


Dirt Bike   Make / Model Specific   Honda   Honda 2-Stroke
  • 2 replies
Forums
Photo

best looking trail bike. by pain99


Dirt Bike   General Dirt Bike Forums   Dirt Bike Pictures & Video
  • Hot  258 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.