Adjusting clutch per service manual isnt working out for me.. help?


1 reply to this topic
  • gregcb53

Posted June 10, 2012 - 03:29 PM

#1

I made the mistake of taking off the clutch Handel. and the pulling off both pieces that allow for clutch adjust. Now after massively fiddling and doing lots of research i till can get the clutch tension correct let alone get the get the bikie out of gear. Prev to removing level the clutch worked perfectly. If any one has any tips, instructions, or pictures It would help a ton, Bike 2001 YZ 426. Thanks in advance

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • cereal killer

Posted June 11, 2012 - 06:45 PM

#2

Check to make sure the lever on top of the gear box is still attached to the cable. If you had the lever off the slack in the cable may have allowed it to pop out without you noticing.

i.e. this:
Posted Image

Edited by cereal killer, June 11, 2012 - 06:46 PM.






Related Content

Forums
Photo

Michigan Motocross Tires by 288yz450


Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply
Forums
Photo

First Hare scramble tips by dhend8


Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  33 replies
Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

YZ450F 03 Sparks driving me crazy by SirAttard


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.