08 and up shifter problem. Let's share solutions!

Started by grogarage , May 18 2012 08:31 AM

1 reply to this topic

  • grogarage

Posted 18 May 2012 - 08:31 AM

#1

I have size 11 feet, the stock shifter is too short for my taste. After reading the treads about that problem, i ordered a 05-07 Sunline shifter (longer that stock) had to grind a notch to clear a case bolt but it worked fine. 2 years later my Sunline shows enough wear at the tip , time to change it.

Hammerhead (+10mm) seems to be the best solution, it's just so expansive

another Sunline is unavailable (in Canada) right now, and i didnt want to grind a notch again...

Will a stock 05-07 shifter will fit without any grinding? I like the quality of OEM parts

thanks!
Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed

  • grogarage

Posted 20 May 2012 - 02:48 PM

#2

i bolted on a stock shifter from a DRZ 400s, works perfect, it clear all case bolts and is almost an inch longer.
Back to RM-Z 450


  1. ThumperTalk
  2. Dirt Bike
  3. Make / Model Specific
  4. Suzuki
  5. RM-Z 450
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.
Register Close

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!