Exhaust pop on decel with FMF powercore4 slip on


3 replies to this topic
  • pschiess

Posted May 09, 2012 - 08:15 AM

#1

The bike is a 2007 WR450F and is stock other than the usual free mods and jetted for the stock pipe. Once I put the FMF Power Core 4 on it I get the occasional POP when chopping the throttle. I have an adjustble fuel screw. Should I adjust it in our out to try to eliminate the decel pop? If so how much. It does not happen all of the time just enough to be annoying.

  • The Hopper Show

Posted May 09, 2012 - 09:40 AM

#2

out

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Pooley

Posted May 09, 2012 - 10:43 AM

#3

A little popping on decel isn't bad, as long as it isn't excessive. Turn your fuel screw out roughly 1/4 turn at a time to richen the mix and eliminate popping. If you stall off-idle, or the hot-start is required too much (where it wasn't before) to restart, you would need to go back a tad leaner (in).

  • pschiess

Posted May 09, 2012 - 10:45 AM

#4

Thanks. That is exactly what i was thinking. I appreciate the help. :banghead:




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.