yes i know i shouldnt even use this stupid bolt but for some reason i decided to take it out when i never use it and figures i try to put it back in and it wont tighten AT ALL. case is completely stripped out. i will never use this bolt again, i rode last weekend with bolt barely in, i can turn bolt with fingers but i was pulling over every 5 minutes making sure it was still in. can i just take bolt out, but just a dab of JB weld on it an put it back in a never touch it agan? or even keep bolt in an just put a drop of jb weld on side of bolt just to keep mit from vibrating out?

No worries, it will. It has been covered here before and JB is just fine. That thing is worthless anyway so just seal it up.

here's the fix

http://www.thumperta..._1#entry9802343