New lifan motor smoking
Posted 11 April 2012 - 12:57 PM
Posted 12 April 2012 - 01:09 PM
Understand I am asuming A LOT with your information given. The guy might have sold you a completely worn out pile of sh*t.
Follow me or ask me a question http://teammgr.weebly.com/ I have lots of info here and constantly update it.
Edited by thejunkman, 12 April 2012 - 01:11 PM.
Posted 12 April 2012 - 05:04 PM
Posted 12 April 2012 - 07:32 PM
Posted 13 April 2012 - 03:59 PM
Posted 13 April 2012 - 04:22 PM
Posted 17 April 2012 - 07:21 AM
It came out of the hole on the right side of the picture which is on the left side of the bike.
Posted 17 April 2012 - 08:38 AM
Posted 17 April 2012 - 12:20 PM
Note to self: No need to remove the cam chain tensioner assembly for an oil change.
Posted 17 April 2012 - 04:50 PM
Posted 24 April 2012 - 02:43 PM
Posted 24 April 2012 - 03:32 PM
Posted 26 April 2012 - 06:15 PM
Posted 03 May 2012 - 05:17 PM
Posted 04 May 2012 - 01:21 PM
Posted 04 May 2012 - 01:28 PM
I assume this is the fuel screw right?
What does this screw do?
and just to clarify which way is choke?
And here's where its leaking oil from
Edited by DMS 56, 04 May 2012 - 01:30 PM.
Posted 05 May 2012 - 04:15 AM
Pic2. That is the idle adjustment screw, to raise or lower the RPMs at idle.
Pic3. That should be choke is ON position. The small groove and slot on the choke handle is where you would attach a choke cable, and, pulling on the choke cable knob or lever would lift the arm up to put the choke ON. You can verify it by removing the airbox and looking at the butterfly plate in the carb.
Pic4. Should be the choke OFF position.
Pic5. There should be a big round gasket behind that clutch adjuster plate, or you could use a thin layer of YamaBond or ThreeBond 1194 to seal it and stop the oil leak.
Posted 05 May 2012 - 04:27 AM