need advice 2011 YZ450 linkage rebuild


1 reply to this topic
  • joeygmx

Posted April 06, 2012 - 12:43 PM

#1

The connecting rod has a hole bored though with a counter bore on each end that is sized to press fit the bearing(outer race). The race is press tight to the bottom of the counter bore. The through hole is the same diameter as the inside diameter of the race. This makes the race pressed in "blind".
Does anyone know an easy way to properly remove these. I have cut off races before with a die grinder but that's not an option in this case. I'm thinking a Blind Hole Bearing Puller with a little heat applied. Any suggestions would be greatly appreciated.
thanx
joey

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted April 06, 2012 - 06:35 PM

#2

I'm thinking a Blind Hole Bearing Puller with a little heat applied.


:thumbsup:





Related Content

Forums
Photo

2014-15 YZ450F Picture thread! Share yours! by motoxjeff


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  215 replies
Forums
Photo

Beginner 2014 YZ 450 F or 2015 YZ 250 F ? by Tomsz


Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • Hot  45 replies
Forums
Photo

Yellow YZ250F at Round 7 of Australian MX Nationals, Conondale QLD by stinkwheels


Dirt Bike   Make / Model Specific   Yamaha   WR/YZ 250F
  • 7 replies
Forums
Photo

2015 yz450 suspension setups share yours by tjhooker


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 12 replies
Reviews

Yamaha YZ450F 2015 by Bryan Bosch


Yamaha YZ450F 2015
  • * * * * -
  • 4 reviews
  • Last review by Tom Riddle
  • On November 12, 2014
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.