1999 WR400 Grey Wire Mod?


1 reply to this topic
  • johndeerekid

Posted March 13, 2012 - 09:24 AM

#1

okay i was planning on doing the grey wire mod to my 99 WR400, but i have a problem. there's 3 sets of wires coming out of the CDI box. 2 of the sets go to a 6 prong connector. the last one goes to a 2 prong connector so i'm pretty sure that's the one i have to use. it has a grey wire and a black wire with a white stripe on it. but here's the dilemma. the connector goes in with 1 grey wire and 1 black like i said but on the other side of the connector, only the black wire comes out. the hole where the grey wire goes in has no wire in it but has a plug in it. so what do i do, did someone already do the mod? do i still have to pull the grey wire? or did it come stock with the wire pulled?

here's what the connector going in looks like-
Posted Image

and here's what it looks like on the other side-
Posted Image

-Wes

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • zibbit u2

Posted March 13, 2012 - 03:50 PM

#2

according to the wiring diagram, it shows what you are displaying in the pictures... 2 leads in.. one wire out.. I don't know why.

I'm thinking the grey wire mod refers to newer generation bike.. ie.. 426's and up.

Edited by rs25, March 13, 2012 - 03:59 PM.





 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.