yz rear fender


2 replies to this topic
  • The Hopper Show

Posted January 26, 2012 - 08:03 PM

#1

i am more than certain its been answered, but could not find it. so, for those of you who have thrown on a yz rear fender and eliminated the tail light, what did you do with the wiring? just black tape it up and leave it unplugged? or do you have to put some sort of resistor in place like you do when you remove the headlight? will the electrical be ok if i just unplug it and go? thanks in advance. bikes a 2005 btw.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • dustdogg

Posted January 26, 2012 - 08:37 PM

#2

I have switched YZ & WR fenders back and forth many times on my 426. When I run the YZ fender I just tape up the connector with electrical tape. Never had any problems. This is all you should need to to.

  • wrwest

Posted January 27, 2012 - 11:20 AM

#3

Do you realy have to put a resistor in place if the headlight is removed? what if the globe fuses? this sounds suspect to me?




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.