oil from around push lever assy?


4 replies to this topic
  • atomic410

Posted October 18, 2011 - 10:47 AM

#1

I replaced the seal which made it go from a gushing amount of oil to a trickle. do the push lever assy's wear out with the seals? It's an 06 yz450f. how common is that? maybe the new seal is bad? I have about 3 years of supermoto racing on it and this is the 1st time its ever had any kind of engine problem. replace the push lever as well?

  • grayracer513

Posted October 18, 2011 - 02:14 PM

#2

The seal could be damaged, improperly installed, etc. The bearing below the seal could have loosened up also, so check that.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • atomic410

Posted October 31, 2011 - 11:22 AM

#3

how does that bearing come out?

  • grayracer513

Posted October 31, 2011 - 01:06 PM

#4

From the top with a blind bearing puller.

  • atomic410

Posted November 01, 2011 - 06:33 AM

#5

thank you. the book doesn't say. i also found a small crack in this area. i want to see how deep it goes. anyone have any experience with jb weld in this area? it take about 5-10 min to pool enough oil to make a drip. tells you how small the crack is.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.