What do i do?/????????

3 replies to this topic
  • boricua1

Posted September 10, 2011 - 12:20 PM


I just installed my new chlutch on my 99 yz 400f : friction plates, steel plates, springs. There were some burn marks on the clutch boss and housing and the push rod #2 looked like it was mushroomed a lil so i know i have to replace that but i put everything bak together and whent to grab the clutch and it doesnt even engage so i tried adjusting the cable and nothin i have no idea what is goin on.

  • DC_Excitement

Posted September 10, 2011 - 03:56 PM


did it have a sleve/ball bearing setup over the big clutch hub nut? im not entirely familar with that specific engine but that ball has fallen out on me before and i diddent notice

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • boricua1

Posted September 10, 2011 - 08:58 PM


im not really sure on that but i think my clutch cable is stretched out but i duno ill go look

  • niles

Posted September 11, 2011 - 06:44 PM


Make sure you lined up the alignment dots

Related Content


Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies

Wilson the Blue Privateer by jetfuel

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies

Michigan Motocross Tires by 288yz450

Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply

Yamaha YZ450F 2017 by Chris.GVS

Yamaha YZ450F 2017
  • * * * * *
  • 1 review
  • Last review by Tommyk_55
  • On Yesterday, 06:20 PM
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.