2009 yz450 linkage service HELP.


1 reply to this topic
  • MichielD

Posted August 23, 2011 - 03:13 AM

#1

Time to service my linkage but it is a bit of a different set up then I'm use to. The collars in the rely arm slide back and forth a little bit but i can't push them out either side. Is there a trick to it? do the seal have to come out first.

The colars are #21 in the picture. again they slide freely back and forth but won' push out of either side to access the bearings.

Posted Image

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • jratcliffe3

Posted August 23, 2011 - 04:19 AM

#2

After popping out the metal caps (#22), with a small screwdriver, the collars should slide straight out. No tricks needed.





Related Content

Forums
Photo

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F


Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies
Forums
Photo

BIGBORE FOR YZ450F 2006? by Taattie94


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 1 reply
Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

Should I buy this bike? help....... by Numsa Hul


Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies
Forums
Photo

2016 YZ450 by CaptainKnobby


Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.