Help, trouble mounting shock WR400

1 reply to this topic
  • fruntrangr

Posted May 11, 2011 - 10:56 AM


Seriously, I've finished replacing all the bearings in the rear end. Now it's time to re-install the shock and I can't get the top bearings to mate up with the frame, it just won't fit. I seems I'm to use the smaller brass colored collars in the bottom end of the shock right?? Any ideas? Anyone else run into this? The shock dropped right out when removed so no damage there. I'm about ready to remove fender and airbox but thought you guys might have some ideas.
Thanks in advance.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • MANIAC998

Posted May 11, 2011 - 07:22 PM


If I'm hearing you correctly, you just need to twist the shock body alittle to get them to line up. It sounds like your upper shock mount isn't perfectly lined up with the lower shock mount. Is this what you mean? Maniac


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.