08 wr 450 cs seal/bushing change


No replies to this topic
  • 066logger

Posted April 19, 2011 - 03:44 PM

#1

first off i searched this and found exactly what i needed to get me to where i am now but now i have a new question lol. so i pull the seal no problemo, then grab my vice grips just like i had read about and after giving the bushing or whatever that is that the seal rides on a few taps with a hammer and it feels pretty froze up. i tried the vice grips anyway but to no avail. i was worried to tap it any harder because i didnt want to damage any internal bearings or anything. so how do you remove that thing? thanks




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.